Core Voltage and Multiplier Jumper Settings for RaQ3/4<br><br>


<b>Core Voltage Jumpers</b><br><br>

Core Voltage Jumpers are to the left of the LCD panel connector on the MB.<br>
Most popular CPU core Voltages are 2.0 and 2.2.<br>
These jumpers are marked R196, R197, R198, R199, and R200<br>

2.0V R197, R198, R199, R200 are installed (Normal for RaQ4)<br>
2.2V only R197 is installed. (Normal for RaQ3)<br><br>

<b>Multiplier Jumpers</b><br><br>

Multiplier Jumpers are to the right of the LCD panel connector on the MB.<br>
These jumpers are marked R207, R208, and R209<br><br>

<li>300MHz only R208 is installed</li>
<li>450MHz R207, R208, and R209 are installed</li>
<li> 500MHz R208 and R209 are installed</li>
<li>550MHz R209 only is installed<br>
<BR>
<b>Note:</b><br>
The jumpers are zero ohm resistors, so a wire works fine.
On a RaQ3, you may run a bare wire across the outboard pads<br>
of the relevent jumper pads, 
as the jumper that is in place will provide the pull down parh.